R-4A (Early) Re-Cap Kit

R-4A (Early) Re-Cap Kit
$35.49
Re-Cap Kit:



Can-Type Electrolytic Capacitor
Original Specs: New Specs:
100 uF @ 200V 100 uF @ 250V
100 uF @ 200V 100 uF @ 250V
100 uF @ 200V 100 uF @ 250V
*** ***
***The early R-4A USUALLY used a three-section can-capacitor, where later versions USUALLY used a four-section unit. Hayseed Hamfest supplies the later version (four-section) can-capacitor in all R-4A kits, including the early versions. In this instance the fourth, or "blank" terminal is left disconnected.

Twist-tab mounting. All sections rated at 105C degrees.
Capacitance and leakage tested. Cap tolerance plus or minus 20%


Discrete Electrolytic Capacitors
Original Specs: New Specs:
2 - 8 uF @ 150V 2 - 10 uF @ 250V
1 - 10 uF @ 25V 1 - 10 uF @ 35V



PLEASE NOTE: Electronics manufacturers often made changes in their products without notice. Occasionally this would change the capacitor complement used in a given unit. We will correct any discrepancies that might occur. However, it makes good sense to compare the specs above with the actual units in your equipment before ordering. This can save everyone considerable time and frustration. Thanks.